I wonder if anyone can help with how to use the RemoveUnderlyingDups macro please? I think it's the macro I'm looking for. having done some Googling. Basically, when I trace a logo, it often comes out with a load of duplicate lines. Which I normally sit there and delete, one by one, until I have a clean image. Ready to send to my plotter, to cut garment vinyl. In the attached picture. I've traced the logo and this is what it comes out like. I've highlighted the traced image, break curves apart, combine, break curves apart again (because I read on another forum you have to do this?) then run the macro. It says 'are you sure you want to delete 74 objects' which sounded promising, but it only removed a few of the duplicate lines and many of them remained. I assume I'm doing something wrong or this macro isn't designed to do what I want it to? Any advice would be much appreciated.
↧